Air Distribution

Component Locations, Part 1:

Component Locations, Part 2:

NOTE: The air distribution system of this vehicle cannot be equipped with a cabin air filter.

There are two sources of air available to the air distribution system:
- outside air
- recirculated air

Recirculated air is only used during MAX A/C, AUTOMATIC and OFF modes if equipped with EATC, or MAX A/C and OFF if equipped with manual A/C.

Air distribution within the vehicle is determined by the function selector switch position, if equipped with manual A/C. If equipped with EATC air distribution is controlled by the electronic automatic temperature control system in the AUTOMATIC mode, but it can be overridden by the driver if desired. Air flow control doors are used to direct air flow within the heater air plenum chamber. Vacuum control motors are used to position these air flow control doors.

The air distribution system is designed to provide air flow from the defroster nozzle when no vacuum is applied to any of the vacuum control motors. This is done to make sure defrost is available in the event of a system vacuum leak.

Air enters the passenger compartment from the:
- instrument panel A/C register.
- heater outlet floor duct.
- windshield defroster nozzle.
- side window demisters.

Passenger compartment air is exhausted from the vehicle through open windows or luggage compartment air vents.