Power Steering System Filling
FillWARNING: Do not mix fluid lopes. Any mixture or any unapproved fluid could lead to seal deterioration and leaks. A leak could ultimately cause loss of fluid, which could result in a loss of power steering assist.
1. Fill the power steering reservoir to the appropriate level.
^ Use Motorcraft MERCON Multipurpose (ATE) Transmission Fluid XT-2-QDX meeting Ford specification MERCON or equivalent.
2. Remove the ignition coil fuse number 7 in the fuse junction panel to disable the engine from starting.
3. Raise the front wheels off the floor.
4. CAUTION: Do not operate the starter motor for more than 10 seconds at a time. Damage to the starter motor could result.
Turn the steering wheel from stop to stop while cranking the engine.
5. Lower the vehicle.
6. CAUTION: Do not overfill the power steering fluid reservoir.
Fill the power steering fluid reservoir to the appropriate level.
^ Use Motorcraft MERCON Multipurpose (ATF) Transmission Fluid XT-2-QDX meeting ford specification MERCON or equivalent.
7. Install the ignition coil fuse number 7 in the fuse junction panel.
8. NOTE: If the power steering is noisy and accompanied by evidence of aerated fluid-it will be necessary to purge the power steering system.
Clear the Diagnostic Trouble Codes (DTCs).
^ Run the vehicle and check the system for leaks.