Component Tests and General Diagnostics

1. Fasten the safety belts and proceed to a safe area.

NOTE: If the RH or the rear safety belts are to be tested, a passenger must be used.

2. Attain a speed of 8 km/h (5 mph).
3. Test the safety belts.
1 Grasp the shoulder harness and prepare to lean forward.
2 Make maximum brake application without a skid.
3 Lean forward slightly when the brake application is made.

NOTE: Do not jerk on the safety belt webbing when carrying out this test.

WARNING: THE DRIVER AND PASSENGER MAST BE PREPARED TO BRACE THEMSELVES IF THE RETRACTOR DOES NOT LOCK.

4. The safety belts should lock up with minimum webbing extension.
5. If there is a lockup of both shoulder straps, the safety belt assemblies are functioning correctly. Should either or both retractors fail to lock up at the 8 km/h (5 mph) speed, repeat the test at a constant 24 km/h (15 mph) speed. (This test must be carried out with a RH front or rear passenger if the RH front or rear outboard safety belts are to be tested.)
6. If either or both shoulder belts do not lock up at the 24 km/h (15 mph) test, return the vehicle for repair of the safety belts.

NOTE: If either or both the shoulder belts do not lock up, the sheet metal in the retractor's mounting surface may need to be returned to its original shape and structural integrity.