Cruise Control Servo Cable: Service and Repair

REMOVAL
1. Disconnect the battery ground cable.







2. Remove the accelerator control splash shield.
1 Remove the pin-type retainers.
2 Remove the splash shield.







3. Disconnect the speed control cable from the throttle cam.
1 Rotate the throttle valve.
2 Disconnect the speed control cable from the throttle cam.
3 Squeeze the speed control cable tabs and remove the cable from the cable bracket.

CAUTION: Make sure the speed control cable is removed in the direction indicated on the cable where it attaches to the throttle cam.







4. Release the speed control cable cap.
1 Depress the speed control cable cap retaining tab.
2 Rotate the speed control cable cap counterclockwise and pull the cable cap away from the servo housing.







5. Remove the speed control cable.
1 Depress the spring retainer.
2 Slide the core wire end out of the speed control servo pulley and remove the speed control cable.

INSTALLATION
1. To install, reverse the removal procedure.