Turn Signal Switch

Steering Column Multifunction Switch

Removal and Installation

1. Disconnect the battery. Refer to Battery.





2. Remove the ignition switch lock cylinder.
1 Insert the ignition key into the ignition switch lock cylinder and turn to the RUN position.
2 Push the ignition switch lock cylinder release tab with a punch while pulling out the ignition switch lock cylinder.





3. Remove the tilt wheel handle and shank.





4. Remove the upper and lower steering column shrouds.
1 Release the upper steering column shroud by pressing the sides inward.
2 Remove the 3 lower steering column shroud screws.
3 Remove the lower steering column shroud.





5. Disconnect the 3 multifunction switch electrical connectors.





6. Remove the 2 screws and the multifunction switch.
7. To install, reverse the removal procedure.