Instrument Cluster Finish Panel

INSTRUMENT CLUSTER FINISH PANEL







Removal and Installation
1. Depower the supplemental restraint system (SRS).
2. Remove the audio unit.
3. Remove the RH instrument panel finish panel and disconnect the 3 electrical connectors.
4. Remove the LH instrument panel finish panel and disconnect the electrical connector.
5. If equipped with steering column shift, place the transmission range selector lever in the 1 position.
6. Tilt the steering column in the full down position.
7. Remove the 8 screws and the instrument cluster finish panel.
- Disconnect the electrical connectors.
- To install, tighten to 3 Nm (27 lb-in)

8. To install, reverse the removal procedure.