Headlamp: Service and Repair
HEADLAMP ASSEMBLYCrown Victoria:
Grand Marquis:
Removal and Installation
NOTE: Make sure the headlamp switch and the ignition switch are in the OFF position.
Crown Victoria
1. Remove the 3 pin-type retainers and the radiator sight shield.
2. Remove the 2 retainers and the headlamp assembly.
- Disconnect the electrical connectors.
Grand Marquis
3. Remove the side turn signal lamp.
4. Remove the 3 bolts and the headlamp assembly.
- Disconnect the electrical connector.
- To install, tighten to 5 Nm (44 lb-in).
All vehicles
5. To install, reverse the removal procedure.
- If necessary, adjust the headlamps.