Audio Unit

AUDIO UNIT







Removal and Installation

CAUTION: For vehicles built through 8/2005, whenever power is disconnected (through the battery or through disconnecting the connector) from the CD6 audio unit, then reconnected, the power must be continuous for a minimum of 25 seconds. Failure to follow this instruction may result in permanent damage to the audio unit.

1. NOTE: Module configuration is only required if a new audio unit is being installed.

Upload the audio unit configuration information to the diagnostic tool.

2. Remove the center instrument cluster finish panel.
- Disengage the clips.

3. Remove the 4 screws and the audio unit.
- Disconnect the electrical connectors and the antenna lead-in cable.

4. To install, reverse the removal procedure.
- Download the configuration information to the audio unit.