Brake Light Switch: Service and Repair

STOPLAMP SWITCH







Removal and Installation

CAUTION: Do not press the brake pedal when removing or installing the stoplamp switch or damage to the switch will occur.

1. Disconnect the stoplamp switch electrical connector.
2. Rotate the stoplamp switch clockwise 45 degrees and remove the stoplamp switch.

3. NOTE: The stoplamp switch is self-adjusting. Do not press the brake pedal during installation. Initial installation of the stoplamp switch allows for one adjustment. If additional adjustments are necessary, install a new stoplamp switch.

To install, reverse the removal procedure.