Battery Cable: Service and Repair

BATTERY CABLES

View 1 Of 2 (Part 1):

View 1 Of 2 (Part 2):

View 2 Of 2 (Part 1):

View 2 Of 2 (Part 2):

Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the battery.
3. Remove the bolt, nut and the battery hold down bracket.
- To install, tighten to 10 Nm (89 lb-in).

4. Remove the bolt and position the battery cable body ground terminal aside
- To install, tighten to 12 Nm (9 lb-ft).

5. Remove the nut and position the BJB cable terminal aside.
- To install, tighten to 8 Nm (71 lb-in).

6. Release the 2 battery cable locators from the battery tray.
7. Remove the bolt and position the battery cable transaxle ground terminal aside.
- To install, tighten to 10 Nm (89 lb-in).

8. Remove the starter solenoid terminal cover.
9. Remove the nut and position the battery cable starter solenoid terminal aside.
- To install, tighten to 12 Nm (9 lb-ft).

10. Release the battery cable locator from the starter stud bolt.
11. Remove the 3 battery cable locators from the rear of the engine.
12. Remove the 2 nuts and the generator shield.
- To install, tighten to 25 Nm (18 lb-ft).

13. Position the generator protective cover aside, remove the nut and position the generator B+ terminal aside.
- To install, tighten to 12 Nm (9 lb-ft).

14. Remove the battery cables.
15. To install, reverse the removal procedure.