Disassembly and Assembly
SEAT CUSHION - FRONTWorldwide Diagnostic System (WDS):
Special Tool(s)
Driver Seat Cushion (Part 1):
Driver Seat Cushion (Part 2):
Passenger Seat Cushion (Part 1):
Passenger Seat Cushion (Part 2):
Disassembly and Assembly
WARNING:
- Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag module. This will reduce the risk of injury in the event of an accidental deployment.
- Never probe the connector on the air bag module. Doing so can result in air bag deployment, which can result in personal injury.
- To reduce the risk of personal injury, do not use any memory saver devices.
NOTE:
- If a seat equipped with a SRS component is being serviced, the SRS must be depowered.
- The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a SRS fault.
- The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
- Driver seat shown, passenger seat similar.
All seats
1. Remove the front seat and depower the supplemental restraint system (SRS).
2. Remove the front seat backrest.
3. Remove the seat track.
4. CAUTION: Use care when separating the seat cushion trim cover from the hook and loop strip, or the hook and loop strip can be torn from the cushion foam pad.
Release the hook and loop strips, remove the hog rings, if equipped and separate the cushion trim cover from the cushion foam pad.
Heated seat
5. If necessary, remove the cushion heater mat and route out the wire harness through the cushion foam pad opening.
- For installation, peel away the paper from the adhesive strips, align and apply the new heater mat to the cushion foam pad being sure to tuck the heater mat into the foam pad creases.
- The heater mat must lay flat on the foam pad with no wrinkles.
Climate controlled seat
6. CAUTION: Before assembly, inspect the climate controlled seat components for damage, crush, obstruction and debris and repair as needed.
If necessary, remove the cushion manifold from the foam pad.
- For installation, align the cushion manifold and insert into the valleys of the foam pad.
- Check for correct fit between the manifold, foam pad and TED assembly, to make sure there is no air flow obstruction or cushion crush.
7. CAUTION: Covering the TED openings is recommended to prevent debris from entering the TED.
Remove the 3 nuts and TED assembly from the cushion frame.
- To install, tighten to 6 Nm (53 lb-in).
- For installation, check for correct fit between the cushion manifold, foam pad and TED assembly, to make sure there is no air flow obstruction, cushion crush or debris.
All seats
8. To assemble, reverse the disassembly procedure.
9. Install the seat track.
10. Install the front seat backrest.
11. Install the front seat and repower the SRS. If a passenger seat has been serviced, do not prove out the SRS at this time.
Passenger seat
12. Carry out the Zero Seat Weight Test and prove out the SRS. Zero Seat Weight Test