Battery Cable: Service and Repair

BATTERY CABLES

View 1 Of 2 (Part 1):

View 1 Of 2 (Part 2):

View 2 Of 2:

Removal and Installation
1. Remove the battery tray.
2. Remove the bolt, nut and the battery hold down bracket.
- To install, tighten to 10 Nm (89 lb-in).

3. Remove the bolt and position the battery cable body ground terminal aside.
- To install, tighten to 12 Nm (9 lb-ft).

4. Remove the nut and position the BJB cable terminal aside.
- To install, tighten to 8 Nm (71 lb-in).

5. Remove the starter solenoid terminal cover.
6. Remove the nut and position the battery cable starter solenoid terminal aside.
- To install, tighten to 12 Nm (9 lb-ft).

7. Release the battery cable locator from the engine.
8. Remove the bolt and position the battery cable transaxle ground terminal aside.
- To install, tighten to 10 Nm (89 lb-in).

9. Release the battery cable locator from the transaxle stud bolt.
10. Release the 3 battery cable locators from the LH valve cover.
11. Position the generator protective cover aside, remove the nut and position the generator B+ terminal aside.
- To install, tighten to 12 Nm (9 lb-ft).

12. Remove the battery cables.
13. To install, reverse the removal procedure.