Rear

Wheel Bearing and Wheel Hub

Special Tool(s):

Removal and Installation

All vehicles
1. Remove the brake disc.
2. Remove and discard the wheel bearing and hub-to-knuckle bolts.
^ To install, tighten to 120 Nm (89 ft. lbs.).
3. If equipped, remove the wheel speed sensor bolt and position the sensor aside.
^ To install, tighten to 8 Nm (71 inch lbs.).

AWD vehicles
4. Remove and discard the rear axle shaft nut.
^ To install, tighten to 200 Nm (148 ft. lbs.).





5. Using the special tool, press the axle shaft out of the hub.

All vehicles

6. NOTE: Always install new suspension fasteners.

To install, reverse the removal procedure.