Starter Motor - 6 Speed

STARTER MOTOR - 6 SPEED







Removal and Installation

WARNING: When carrying out maintenance on the starting system, be aware that the heavy gauge leads are connected directly to the battery. Make sure the protective caps are in place when maintenance is completed.

1. Disconnect the battery ground cable.
2. Remove the air cleaner outlet pipe.
3. Remove the transaxle roll restrictor bolt.
- To install, clean the bolt using a wire brush, apply new threadlock to the threads and tighten to 48 Nm (35 lb-ft).

4. Remove the 4 bolts and the transaxle roll restrictor cross brace assembly.
- To install, clean the bolts using a wire brush, apply new threadlock to the threads and tighten to 55 Nm (41 lb-ft).

5. Remove the starter solenoid terminal cover.

6. NOTE: Detach any harness pin-type retainers that restrict movement of the wiring harness.

Remove the nuts and position the starter solenoid cables aside.
- To install, tighten the large nut to 12 Nm (9 lb-ft).
- To install, tighten the small nut to 6 Nm (53 lb-in).

7. Remove the bolts and the starter motor.
- To install, tighten to 25 Nm (18 lb-ft).

8. To install, reverse the removal procedure