Front Door Window Glass: Service and Repair

WINDOW GLASS - FRONT DOOR

Part 1:

Part 2:

Exploded View

Removal and Installation

NOTE:
- For MKZ only, if installing a new LH or RH front window motor, it must be initialized.
- For MKZ only, the LH or RH front window motor must be de-initialized, then initialized whenever the front window motor is removed from the window regulator drum housing, a new window regulator is installed, a new window glass is installed, a new top run is installed or for any operation in which grease or lubricants are applied to the window regulator or glass run.

1. Remove the front door trim panel.







2. Remove the wiring harness cover plate and the access hole plug.

3. NOTE: If the window regulator motor is inoperative, remove it.

Lower the window until the glass clamp bolts can be accessed through the access holes.







4. Loosen the B-pillar front door window glass clamp bolt.
- To install, tighten to 6 Nm (53 lb-in).







5. Loosen the A-pillar front door window glass clamp bolt.
- To install, tighten to 6 Nm (53 lb-in).

6. Tape the window in position, then lower the window regulator downward until it reaches the stops at the bottom of the regulator tracks.
7. Lift the window glass out of the door.
8. To install, reverse the removal procedure.
- For MKZ only, if installing a new LH or RH front window motor, it must be initialized. If installing the original front window motor, it must be de-initialized, then initialized.