Rear
Wheel Bearing and Wheel HubSpecial Tool(s):
Removal and Installation
All vehicles
1. Remove the brake disc.
2. Remove and discard the wheel bearing and hub bolts.
^ To install, tighten to 120 Nm (89 ft. lbs.).
3. If equipped, remove the wheel speed sensor bolt and position the sensor aside.
^ To install, tighten to 14 Nm (10 ft. lbs.).
All wheel drive (AWD) vehicles
4. Remove and discard the rear axle shaft nut.
^ To install, tighten to 350 Nm (258 ft. lbs.).
5. Using the special tool, press the axle shaft out of the hub.
All vehicles
6. NOTE: Always install new suspension fasteners.
To install, reverse the removal procedure.