Rear

Stabilizer Bar - Front Wheel Drive (FWD)

NOTE: LH side shown, RH side similar









Removal and Installation

CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure can result in major service expense. A new part with the same part number must be installed if installation is necessary. Do not use a new part of lesser quality or substitute design. Torque values must be used as specified to make sure of correct retention of these parts.

1. With the vehicle in NEUTRAL, position it on a hoist.
2. Lower the exhaust system from the rear of the flex pipe by disconnecting the insulators. Support the exhaust system with a suitable jack.
3. Remove and discard the stabilizer bar link lower nuts.
^ To install, tighten to 55 Nm (41 ft. lbs.)
3. Remove and discard the stabilizer bar bracket bolts.
^ To install, tighten to 55 Nm (41 ft. lbs.).
4. Remove the stabilizer bar.

5. NOTE: Always install new suspension fasteners.

To install, reverse the removal procedure.