Front Door Window Glass: Service and Repair

WINDOW GLASS-FRONT DOOR







Exploded View

Removal and Installation

NOTE:
- If installing a new LH front window motor, it must be initialized.
- The LH front window motor must be de-initialized, then initialized whenever the LH front window motor is removed from the window regulator drum housing, a new window regulator is installed, a new window glass is installed, a new top run is installed or for any operation in which grease or lubricants are applied to the window regulator or glass run.

1. Remove the front door trim panel and water shield.
2. Remove the front door speaker.

3. NOTE: If the window regulator motor is inoperative, remove it.

Lower the window until the glass clamp bolts can be accessed through the rear access hole and front door speaker opening.







4. Loosen the B-pillar front door window glass clamp bolt.
- To install, tighten to 8 Nm (71 lb-in).







5. Loosen the A-pillar front door window glass clamp bolt.
- To install, tighten to 8 Nm (71 lb-in).

6. Tape the window in position, then lower the window regulator downward until it reaches the stops at the bottom of the regulator tracks.
7. Lift the window glass out of the door.
8. To install, reverse the removal procedure.
- If installing a new LH front window motor, it must be initialized. If installing the original LH front window motor, it must be de-initialized, then initialized.