Procedures

ROOF OPENING PANEL MANUAL OPERATION

1. Remove the LH and RH A-pillar trim panels.
- Position the weatherstrip aside near the A-pillar.
- Pull the outboard edge of the A-pillar trim panel toward the inside of the vehicle to disengage the retaining clips.
- Pull the A-pillar trim panel upward to remove from the dash panel.

2. Remove the LH and RH sun visor assemblies.
- Remove the 3 sun visor retaining screws.
- Disconnect the sun visor wire harness electrical connector.
- Remove the sun visor arm clip screw.
- Remove the sun visor arm clip.

3. Remove the overhead console.
- Open the bin and remove the screws.
- Disconnect the overhead console electrical connector.

4. If equipped, disconnect the auto-dimming electrical connector from the interior rear view mirror.
5. Pull down front of headliner to gain access to the roof opening panel motor.







6. Insert an Allen wrench into the center of the manual drive hole. Rotate the Allen wrench counterclockwise until the roof opening panel is closed.