Pinpoint Test AA: DTC B19A1
Seats
Pinpoint Tests
Pinpoint Test AA: DTC B19A1
Refer to Wiring Diagram Set 119, Climate Controlled Seats for schematic and connector information. Diagrams By Number
Normal Operation
The Dual Climate Controlled Seat Module (DCSM) supplies a speed control signal voltage to the passenger seat cushion Thermo-Electric Device (TED) on circuit VHS23 (BN/BU). The TED blower is supplied operating voltage from DCSM output circuit CHS08 (BN/YE) and ground from DCSM output circuit RHS08 (VT/WH).
- DTC B19A1 Passenger Seat Cushion Blower Speed Short to Battery - If the passenger seat cushion blower speed circuit is shorted to voltage, the DCSM will shut down the passenger seat system and set this DTC.
This pinpoint test is intended to diagnose the following:
- Wiring, terminals or connectors
- TED and blower assembly
- DCSM
PINPOINT TEST AA: DTC B19A1
NOTICE: Use the correct probe adapter(s) from the Flex Probe Kit when taking measurements. Failure to use the correct probe adapter(s) may damage the connector.
NOTICE: When taking measurements at Dual Climate Controlled Seat Module (DCSM) harness connectors, do not insert the electrical probes into the female connector pins. Inserting the probes into connector pins can cause intermittent or open electrical connections after reassembly resulting in diagnostic trouble codes (DTCs) and system failure. Touching the tip of these connector pins is recommended instead.
NOTE: The air bag warning indicator illuminates when the correct Restraints Control Module (RCM) fuse is removed and the ignition switch is ON.
NOTE: The Supplemental Restraint System (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.
-------------------------------------------------
AA1 CHECK CUSHION TED BLOWER SPEED CONTROL CIRCUIT VHS23 (BN-BU) FOR A SHORT TO VOLTAGE
- Ignition OFF.
- Depower the SRS. Refer to Supplemental Restraint System (SRS) Depowering and Repowering in the General Procedures portion of Air Bag Systems.
- Disconnect: Passenger Seat Side Air Bag C313.
- Disconnect: DCSM C3305c.
- WARNING: Make sure no one is in the vehicle and there is nothing blocking or placed in front of any air bag module when the battery is connected. Failure to follow these instructions may result in serious personal injury in the event of an accidental deployment.
- Connect the battery ground cable. Refer to Battery.
- Ignition ON.
- Measure voltage between C3305c-3, circuit VHS23 (BN/BU), harness side and ground.
- Is any voltage present?
Yes
GO to AA2.
No
GO to AA3.
-------------------------------------------------
AA2 CHECK CUSHION TED BLOWER SPEED CONTROL CIRCUIT VHS23 (BN-BU) FOR A SHORT TO VOLTAGE
- Disconnect: Cushion TED C3303.
- Measure voltage between DCSM C3305c-3, circuit VHS23 (BN/BU), harness side and ground.
- Is any voltage present?
Yes
REPAIR the circuit. REPEAT the self-test. CLEAR the DTCs.
DISCONNECT the battery ground cable.
CONNECT passenger seat side air bag module C313.
REPOWER the SRS. REFER to Air Bag Systems.
No
GO to AA3.
-------------------------------------------------
AA3 CHECK CUSHION TED BLOWER SPEED CONTROL AND BLOWER OUTPUT CIRCUITS CHS08 (BN/YE) and VHS23 (BN/BU) FOR A SHORT TOGETHER
- Ignition OFF.
- Disconnect: Cushion TED C3303.
- Measure resistance between DCSM C3305c-3, circuit VHS23 (BN/BU), harness side and C3305c-8, circuit CHS08 (BN/YE), harness side.
- Is resistance greater than 10,000 ohms?
Yes
GO to AA4.
No
REPAIR the circuits. REPEAT the self-test. CLEAR the DTCs.
DISCONNECT the battery ground cable.
CONNECT passenger seat side air bag module C313.
REPOWER the SRS. REFER to Air Bag Systems.
-------------------------------------------------
AA4 CHECK CUSHION TED RESISTANCE FOR AN INTERNAL SHORT
- Measure resistance between cushion TED C3303 pin 2 and pin 7, component side.
- Is resistance greater than 2,000,000 ohms?
Yes
INSTALL a new DCSM and CARRY OUT Programmable Module Installation (PMI). REFER to Dual Climate Controlled Seat Module (DCSM) Dual Climate Controlled Seat Module (DCSM). REPEAT the self-test. CLEAR the DTCs.
DISCONNECT the battery ground cable.
CONNECT passenger seat side air bag module C313.
REPOWER the SRS. REFER to Air Bag Systems.
No
INSTALL a new cushion TED. REFER to Seat Cushion Thermo-Electric Device Seat Cushion Thermo-Electric Device. REPEAT the self-test. CLEAR the DTCs.
DISCONNECT the battery ground cable. CONNECT passenger seat side air bag module C313.
REPOWER the SRS. REFER to Air Bag Systems.
-------------------------------------------------