Part 3
135. Install the coolant pump pulley and the 3 bolts.
^ Tighten to 20 Nm (15 lb-ft).
136. Install the A/C compressor and the 3 bolts.
^ Tighten to 25 Nm (18 lb-ft).
137. Install the A/C manifold and the bolt.
^ Tighten to 25 Nm (18 lb-ft).
138. Connect the A/C compressor electrical connector.
139. Position the coolant hose on the engine and connect the coolant hose to the throttle body.
140. Connect the lower radiator and heater hoses to the thermostat housing.
141. Connect the KS electrical connector and the 2 harness pin-type retainers.
142. Install the power steering pump and the lower bolt.
^ Finger tighten the bolt.
143. Install the 2 upper power steering pump bolts.
^ Tighten all 3 power steering bolts to 25 Nm (18 lb-ft).
144. Connect the power steering pressure (PSP) switch electrical connector.
145. Install the accessory drive belt tensioner and the 2 bolts.
^ Tighten to 25 Nm (18 lb-ft).
146. Position the accessory drive belt onto the tensioner and all of the accessory drive pulleys except the coolant pump pulley.
147. Using the hex feature, rotate the accessory drive belt tensioner clockwise and install the accessory drive belt onto the coolant pump pulley.
148. Using the Heavy Duty Floor Crane and Spreader Bar, remove the engine from the engine stand.
Vehicles with automatic transaxle
149. Install the flexplate and the 6 bolts. Tighten the 6 bolts in the sequence shown in 3 stages:
^ Stage 1: Tighten to 50 Nm (37 lb-ft).
^ Stage 2: Tighten to 80 Nm (59 lb-ft).
^ Stage 3: Tighten to 112 Nm (83 lb-ft).
Vehicles with manual transaxle
150. Install the flywheel and the 6 bolts. Tighten the 6 bolts in the sequence shown in 3 stages:
^ Stage 1: Tighten to 50 Nm (37 lb-ft).
^ Stage 2: Tighten to 80 Nm (59 lb-ft).
^ Stage 3: Tighten to 112 Nm (83 lb-ft).
151. Install the starter motor isolator.
152. Lubricate the transaxle input shaft pilot bearing with front axle grease.
153. Using the special tool, position the clutch disc on the flywheel.
154. NOTE: If reusing the clutch pressure plate and flywheel, align the marks made during removal.
Position the clutch pressure plate and install the 6 bolts.
^ Tighten to 29 Nm (21 lb-ft) in a star pattern sequence.