Air Cleaner

Air Cleaner

Removal and Installation

1. Disconnect the Mass Air Flow (MAF) sensor electrical connector.

2. Loosen the clamp and disconnect the Air Cleaner (ACL) outlet pipe from the air cleaner.
- To install, tighten to 5 Nm (44 lb-in).

3. NOTE: No tools are needed to remove the ACL assembly. Removal should be carried out using hands only.

Separate the 3 ACL feet from the rubber grommets and the ACL inlet pipe and remove the ACL assembly.

4. NOTE: Make sure that the 3 ACL feet are seated into the rubber grommets under the ACL assembly.

NOTE: The ACL outlet pipe should be securely sealed to prevent unmetered air from entering the engine.

To install, reverse the removal procedure.