Sound Deadeners and Insulators

Sound Deadeners and Insulators

NOTICE: Mastic is made of a combustible material and should be removed prior to carrying out welding procedures to the area. Heat zones from welding near the mastic may cause the mastic material to burn.

NOTICE: Corrosion protection must be restored to the area AFTER the mastic material is applied. Corrosion protection products contain wax and loss of adhesion may occur.

NOTE: To restore the vehicle to design intent, missing or damaged sound deadeners and insulators should be installed with the correct service replacement component.

NOTE: The following illustrations serve as a reference to indicate mastic sound deadener locations. Sound deadener material is applied from the factory in a pumpable form. Additional insulators and sound deadeners are used beyond those indicated in the illustration.

Interior Floor Pan

NOTE: Arrow indicates rear of vehicle.






Exterior Floor Pan

NOTE: Arrow indicates rear of vehicle.






1. Whenever replacement of an existing mastic insulator is carried out, the surface must be thoroughly cleaned to make sure correct adhesion will occur. The surface should be 10°C (50°F) or greater before applying the mastic. The use of a heat gun to warm the metal surface will aid in adhesion.