Battery Cable: Service and Repair

Battery Cables - 3.0L

View 1 of 2










View 2 of 2









Removal and Installation

1. Remove the battery tray. For additional information, refer to Battery Tray Battery Tray.

2. Remove the bolt, nut and the battery hold-down bracket.
- To install, tighten to 10 Nm (89 lb-in).

3. Remove the bolt and position the battery cable body ground terminal aside.
- To install, tighten to 12 Nm (106 lb-in).

4. Remove the nut and position the Battery Junction Box (BJB) cable terminal aside.
- To install, tighten to 8 Nm (71 lb-in).

5. Remove the starter solenoid terminal cover.

6. Remove the nut and position the battery cable starter solenoid terminal aside.
- To install, tighten to 12 Nm (106 lb-in).

7. Release the battery cable locator from the engine.

8. Remove the bolt and position the battery cable transaxle ground terminal aside.
- To install, tighten to 10 Nm (89 lb-in).

9. Release the battery cable locator from the transaxle stud bolt.

10. Release the 3 battery cable locators from the LH valve cover.

11. Position the generator protective cover aside, remove the nut and position the generator B+ terminal aside.
- To install, tighten to 12 Nm (106 lb-in).

12. Remove the battery cables.

13. To install, reverse the removal procedure.