Pinpoint Test AG: DTC B19A7
Seats
Pinpoint Tests
Pinpoint Test AG: DTC B19A7
Refer to Wiring Diagram Set 119, Climate Controlled Seats for schematic and connector information. Diagrams By Number
Normal Operation
The Dual Climate Controlled Seat Module (DCSM) supplies a speed control signal voltage to the driver seat cushion Thermo-Electric Device (TED) on circuit VHS18 (BN/GN). The TED blower is supplied operating voltage from DCSM output circuit CHS03 (GN/BN) and ground from DCSM output circuit RHS03 (GY/OG).
- DTC B19A7 Driver Seat Cushion Blower Speed Short to Ground - If the driver seat cushion blower speed circuit is shorted to ground, the DCSM will shut down the driver seat system and set this DTC.
This pinpoint test is intended to diagnose the following:
- Wiring, terminals or connectors
- TED and blower assembly
- DCSM
PINPOINT TEST AG: DTC B19A7
NOTICE: Use the correct probe adapter(s) from the Flex Probe Kit when taking measurements. Failure to use the correct probe adapter(s) may damage the connector.
NOTICE: When taking measurements at Dual Climate Controlled Seat Module (DCSM) harness connectors, do not insert the electrical probes into the female connector pins. Inserting the probes into connector pins can cause intermittent or open electrical connections after reassembly resulting in diagnostic trouble codes (DTCs) and system failure. Touching the tip of these connector pins is recommended instead.
NOTE: The air bag warning indicator illuminates when the correct Restraints Control Module (RCM) fuse is removed and the ignition switch is ON.
NOTE: The Supplemental Restraint System (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.
-------------------------------------------------
AG1 CHECK CUSHION TED BLOWER SPEED CONTROL CIRCUIT VHS18 (BN/GN) FOR A SHORT TO GROUND
- Ignition OFF.
- Depower the SRS. Refer to Supplemental Restraint System (SRS) Depowering and Repowering in the General Procedures portion of Air Bag Systems.
- Disconnect: Driver Seat Side Air Bag C327.
- Disconnect: DCSM C3305c.
- Disconnect: Cushion TED C3300.
- Measure resistance between DCSM C3305c-11, circuit VHS18 (BN/GN), harness side and ground.
- Is resistance greater than 10,000?
Yes
GO to AG2.
No
REPAIR the circuit. REPEAT the self-test. CLEAR the DTCs.
CONNECT driver seat side air bag module C327.
REPOWER the SRS. REFER to Air Bag Systems.
-------------------------------------------------
AG2 CHECK CUSHION TED BLOWER SPEED CONTROL CIRCUIT VHS18 (BN/GN) AND BLOWER GROUND CIRCUIT RHS03 (GY/OG) FOR A SHORT TOGETHER
- Measure resistance between DCSM C3305c-11, circuit VHS18 (BN/GN), harness side and C3305c-15, circuit RHS03 (GY/OG), harness side.
- Is resistance greater than 10,000?
Yes
GO to AG3.
No
REPAIR the circuits. REPEAT the self-test. CLEAR the DTCs.
CONNECT driver seat side air bag module C327.
REPOWER the SRS. REFER to Air Bag Systems.
-------------------------------------------------
AG3 DETERMINE CUSHION TED OR DCSM FAILURE
- Remove the cushion TED from the driver seat. Refer to Seat Cushion Thermo-Electric Device Seat Cushion Thermo-Electric Device.
- Remove the cushion TED from the passenger seat and install it on the driver seat.
- Connect: Cushion TED C3300.
- Connect: DCSM C3305c.
- WARNING: Make sure no one is in the vehicle and there is nothing blocking or placed in front of any air bag module when the battery is connected. Failure to follow these instructions may result in serious personal injury in the event of an accidental deployment.
- Connect the battery ground cable. Refer to Battery.
- Start the engine and check operation of the driver seat climate controlled seat system.
- Does the seat operate with the TED from the other seat installed?
Yes
INSTALL a new cushion TED. REFER to Seat Cushion Thermo-Electric Device Seat Cushion Thermo-Electric Device. REPEAT the self-test. CLEAR the DTCs.
DISCONNECT the battery ground cable.
CONNECT driver seat side air bag module C327.
REPOWER the SRS. REFER to Air Bag Systems.
No
INSTALL a new DCSM. REFER to Dual Climate Controlled Seat Module (DCSM) Dual Climate Controlled Seat Module (DCSM). REPEAT the self-test.
CLEAR the DTCs.
DISCONNECT the battery ground cable.
CONNECT driver seat side air bag module C327.
REPOWER the SRS. REFER to Air Bag Systems.
-------------------------------------------------