Window Glass - Front Door

Window Glass - Front Door





Removal and Installation

1. Remove the front door trim panel.

2. Remove the speaker. For additional information, refer to Accessories and Optional Equipment.

3. Remove the screws and position the Driver Door Module (DDM) aside.





4. Position the upper and lower water shields aside.

5. Remove the rivets and position the door latch remote control aside.





6. Remove the 2 front door glass top run bolts.
- To install, tighten to 12 Nm (106 lb-in).

7. Remove the inner belt line moulding.

8. Remove the nut and outer belt line moulding.
- To install, tighten to 12 Nm (106 lb-in).

9. Position the front door glass run front retainer forward.

10. Connect the window control switch electrical connectors.

11. Lower the front door window glass to gain access to the rivets.

12. NOTICE: Do not attempt to forcibly remove the rivets as damage to the front door window glass will result.

NOTE: Before removing rivets, it is necessary to place a suitable block support between the front door window channel bracket and the door outer panel to help stabilize the front door window bracket during rivet removal.

Remove the 2 rivets.





13. Remove the front door window glass.





14. NOTE: If necessary, align the front door window glass with the front door window channel bracket.

To install, reverse the removal procedure.

- Using the Heavy Duty Riveter, install the 2 spacers and two 1/4 inch rivets (use of 1/4 - 20 x 1 inch screw and washer assemblies and 1/4 inch - 20 nut and washer are optional). Tighten the nut (if used) to 13 Nm (115 lb-in).