Pinpoint Tests BT: DTC U0208:00

Instrumentation, Message Center and Warning Chimes

Pinpoint Tests

Pinpoint Test BT: DTC U0208:00

Normal Operation
- DTC U0208:00 (Lost Communication With "Seat Control Module A": No Sub-Type Information) - sets in the Instrument Panel Cluster (IPC) if data messages received from the Driver Seat Module (DSM) over the Medium Speed Controller Area Network (MS-CAN) are missing. For a complete list of all network messages, refer to Information Bus.

This pinpoint test is intended to diagnose the following:

- DSM
- IPC



PINPOINT TEST BT: DTC U0208:00

-------------------------------------------------
BT1 VERIFY THE CUSTOMER CONCERN


- Ignition ON.
- Verify that there is an observable symptom present.
- Is an observable symptom present?

Yes
GO to BT2.

No
The system is operating normally at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.

-------------------------------------------------
BT2 CHECK THE COMMUNICATION NETWORK


- Ignition ON.
- Enter the following diagnostic mode on the scan tool: Network Test .
- Carry out the network test.
- Does the DSM pass the network test?

Yes
GO to BT3.

No
REFER to Information Bus.

-------------------------------------------------
BT3 RETRIEVE THE RECORDED DTCs FROM THE IPC SELF-TEST


- Check for recorded DTCs from the IPC self-test.
- Is DTC U3003:16 or DTC U3003:17 recorded?

Yes
GO to Pinpoint Test BX (U3003:16) or GO to Pinpoint Test BY (U3003:17). Pinpoint Tests BX: DTC U3003:16 Pinpoint Tests BY: DTC U3003:17

No
GO to BT4.

-------------------------------------------------
BT4 RECHECK THE IPC DTCs


NOTE: If new modules were installed prior to the DTC being set, the module configuration may be incorrectly set during the Programmable Module Installation (PMI) or the PMI may not have been carried out.

- Clear the DTCs. Repeat the IPC self-test.
- Is DTC U0208:00 still present?

Yes
INSTALL a new DSM. REFER to Body Control Systems. CLEAR the DTCs. REPEAT the IPC self-test.

If DTC U0208:00 is still present, INSTALL a new IPC. REFER to Instrument Panel Cluster (IPC) Instrument Panel Cluster (IPC). TEST the system for normal operation.

No
The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.

-------------------------------------------------