Bumper - Rear

Bumper - Rear





Removal and Installation

WARNING: Before servicing a vehicle equipped with a fire suppression system, depower the system by following the procedure in Fire Suppression System. Failure to follow the instructions may result in serious personal injury Procedures.

1. Remove the rear bumper cover. For additional information, refer to Bumper Cover - Rear Service and Repair.

2. Remove the 4 rear bumper nuts (2 each side) and the rear bumper.
- To install, tighten to 40 Nm (30 lb-ft).

3. If necessary, remove the 2 rear bumper cover brackets and rivets.

4. To install, reverse the removal procedure.
- Use the Heavy-Duty Riveter to install the new rivets.