Seat - Front

Seat - Front

NOTE: Driver seat shown, passenger similar.











Removal

WARNING: Never probe the electrical connectors on air bag, Safety Canopy(R) or side air curtain modules. Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.

NOTE: The air bag warning indicator illuminates when the correct Restraints Control Module (RCM) fuse is removed and the ignition is on.

NOTE: The Supplemental Restraint System (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.

1. Position the seat to allow access to the front and rear retainers.

2. Depower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering in the General Procedures portion of Supplemental Restraint System Supplemental Restraint System (SRS) Depowering and Repowering.

3. Remove the 2 seat track-to-floor nut covers.

4. Remove the 2 seat track-to-floor nuts.

5. Remove the 2 seat track-to-floor bolt covers.

6. Remove the 2 seat track-to-floor bolts.

7. Disconnect the electrical connectors and detach the wiring harness pin-type retainer from the seat track.





8. NOTICE: Use care when handling the seat and track assembly. Dropping the assembly or sitting on a seat not secured in the vehicle may result in damaged components.

Remove the seat from the vehicle.

Installation

1. NOTE: Before installation, make sure the safety belt webbing is not twisted and the safety belts and buckles are accessible to the occupants.

Position the seat in the vehicle and the safety belt anchor to the seat mounting stud.

2. Connect the electrical connectors and attach the wiring harness pin-type retainer to the seat track.





3. Install the rear inboard seat track-to-floor nut.
- Before installing the inboard seat track-to-floor nut, make sure the center seat safety belt buckle anchor is correctly positioned to the seat track.

- Tighten to 80 Nm (59 lb-ft).

4. Position the safety belt anchor and install the rear outboard seat track-to-floor nut.
- Tighten to 25 Nm (18 lb-ft).

5. Install the 2 seat track-to-floor nut covers.

6. Install the 2 seat track-to-floor bolts.
- Tighten to 25 Nm (18 lb-ft).

7. Install the 2 seat track-to-floor bolt covers.

8. Repower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering in the General Procedures portion of Supplemental Restraint System Supplemental Restraint System (SRS) Depowering and Repowering.