Air Inlet Duct

Air Inlet Duct

Removal and Installation

1. WARNING: Before servicing a vehicle equipped with a fire suppression system, depower the system by following the procedure in Fire Suppression System. Failure to follow the instructions may result in serious personal injury Procedures.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Jacking and Lifting Service and Repair.

2. Remove the plenum chamber. For additional information, refer to Plenum Chamber Plenum Chamber.

3. Remove the RH front wheel and tire.

4. Remove the bolts and reposition the fender apron.





5. Remove the bolt.





6. Remove the screws and the pin-type retainer and reposition the cowl top cover to access the air inlet duct nut.





7. Remove the nut.





8. Remove the nut and position the harness cover aside.





9. Remove the nut.





10. Inside the vehicle, remove the bolt.





11. Detach the wire harness.





12. Detach the electrical connectors and remove the air inlet duct.





13. WARNING: If the vehicle is equipped with a fire suppression system, repower the system. For important safety warnings and procedures, refer to Fire Suppression System. Failure to follow these instructions may result in serious personal injury Description and Operation.

To install, reverse the removal procedure.