Window Glass - Rear Door

Window Glass - Rear Door





Removal and Installation

1. Remove the rear door trim panel. For additional information, refer to Interior Trim and Ornamentation Service and Repair.

2. Position the water shields aside.

3. Remove the 3 rivets and position the rear door latch remote control aside.





4. Remove the inner belt line moulding.

5. Remove the nut and outer belt line moulding.
- To install, tighten to 12 Nm (106 lb-in).

6. Remove the rear door glass top run inner bolt.
- To install, tighten to 10 Nm (89 lb-in).

7. Connect the window control switch electrical connectors.

8. Lower the rear door window glass to gain access to the rivets.

9. NOTICE: Do not attempt to forcibly remove the rivets as damage to the rear door window glass may result. Prior to removing the rivet center pins, it is necessary to place a suitable block support between the door outer panel and the rear door window channel bracket to stabilize the rear door window glass during rivet removal.

Remove the 2 rear door window regulator rivets.





10. Remove the rear door glass top run outer bolt.
- To install, tighten to 12 Nm (106 lb-in).

11. Remove the rear door window glass.





12. NOTE: If necessary, align the rear door window glass with the rear door window channel bracket.

To install, reverse the removal procedure.

- Using the Heavy Duty Riveter, install 2 spacers and two 1/4 inch rivets (use of 1/4 - 20 x 1 inch screw and washer assemblies and 1/4 inch - 20 nut and washer are optional). Tighten the nut (if used) to 13 Nm (115 lb-in).