Pinpoint Test AD: DTC U0140

Handles, Locks, Latches and Entry Systems

Pinpoint Test AD: DTC U0140

Refer to Wiring Diagram Set 14 (Fusion/Milan/MKZ, Fusion Hybrid, Milan Hybrid, MKZ Hybrid), Module Communications Network for schematic and connector information. Diagrams By Number

Normal Operation

The Driver Door Module (DDM) and the Smart Junction Box (SJB) communicate using the Medium Speed Controller Area Network (MS-CAN). Messages are exchanged between the modules on the MS-CAN for the purposes of determining what functions are being carried out.

- DTC U0140 (Lost Communication With Body Control Module (GEM)) - set by the DDM whenever it has lost communication to the SJB for 15 seconds or longer as long as the module voltage is between 10 and 15 volts.

This pinpoint test is intended to diagnose the following:


- Module communication
- DDM
- SJB


PINPOINT TEST AD: DTC U0140

-------------------------------------------------
AD1 VERIFY CUSTOMER CONCERN

- Ignition ON.
- Verify there is an observable symptom present.
- Is an observable symptom present?

Yes
GO to AD2.

No
The system is operating normally at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.

-------------------------------------------------
AD2 CHECK THE COMMUNICATION NETWORK

- Ignition ON.
- Enter the following diagnostic mode on the scan tool: Network Test.
- Carry out the network test.
- Does the SJB pass the network test?

Yes
GO to AD3.

No
REFER to Module Communications Network Testing and Inspection.

-------------------------------------------------
AD3 RETRIEVE THE RECORDED DTCs FROM THE SELF-TEST

- Check for recorded DDM DTCs from the self-test.
- Is DTC B1317 or DTC B1318 recorded?

Yes
For DTC B1317, GO to Pinpoint Test AB. Pinpoint Test AB: DTC B1317

For DTC B1318, GO to Pinpoint Test AC. Pinpoint Test AC: DTC B1318

No
GO to AD4.

-------------------------------------------------
AD4 RECHECK THE DDM DTCs

NOTE: If new modules were installed prior to the DTC being set, the module configuration may be incorrectly set during Programmable Module Installation (PMI) or the PMI may not have been carried out.

- Clear the DTCs. Repeat the DDM self-test.
- Is DTC U0140 still present?

Yes
GO to AD5.

No
The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.

-------------------------------------------------
AD5 CHECK FOR DTC U0140/U0140:00 SET IN OTHER MODULES

- Clear all DTCs.
- Ignition OFF.
- Ignition ON.
- Wait 10 seconds.
- Enter the following diagnostic mode on the scan tool: Self-Test.
- Retrieve the continuous memory DTCs from all modules.
- Is DTC U0140/U0140:00 set in other modules?

Yes
INSTALL a new SJB. REFER to Multifunction Electronic Modules Service and Repair.

No
INSTALL a new DDM. REFER to Driver Door Module (DDM) Service and Repair.

-------------------------------------------------