Air Cleaner

Air Cleaner

Removal and Installation

1. Disconnect the Mass Air Flow (MAF) sensor electrical connector.

2. Loosen the clamp and disconnect the Air Cleaner (ACL) outlet pipe-to-ACL housing cover.
- To install, tighten to 4 Nm (35 lb-in).

3. NOTE: No tools are needed to remove the ACL assembly. Removal should be carried out using hands only.

Separate the 3 ACL feet from the rubber grommets and the ACL inlet pipe and remove the ACL assembly.

4. NOTE: Make sure that the 3 ACL feet are seated into the rubber grommets under the ACL assembly.

NOTE: The ACL outlet pipe should be securely sealed to prevent unmetered air from entering the engine.

To install, reverse the removal procedure.