Seat Position Sensor: Service and Repair

Seat Position Sensor









NOTE: The air bag warning indicator illuminates when the correct Restraints Control Module (RCM) fuse is removed and the ignition switch is ON.

NOTE: The Supplemental Restraint System (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.

1. Remove the driver seat. For additional information, refer to Seating Seat - Front.

2. Disconnect the seat position sensor electrical connector.

3. Remove the bolt and seat position sensor.
- To install, tighten to 6 Nm (53 lb-in).

4. WARNING: Always tighten the seat position sensor retaining bolt to specified torque. Failure to do so may result in incorrect restraint system operation, which increases the risk of personal injury or death in a crash.

To install, reverse the removal procedure.

5. Install the driver seat. For additional information, refer to Seating Seat - Front.