Pinpoint Test Y: Manual Door Lock Cylinder Inoperative

Handles, Locks, Latches and Entry Systems

Pinpoint Test Y: Manual Door Lock Cylinder Inoperative

Normal Operation

The door lock cylinder is connected to the door latch via a lock rod and can be used to manually lock/unlock a door.

This pinpoint test is intended to diagnose the following:

- Bent or binding lock rod and lever
- Door lock cylinder
- Door latch


PINPOINT TEST Y: MANUAL DOOR LOCK CYLINDER INOPERATIVE

-------------------------------------------------
Y1 CHECK THE LOCK CYLINDER OPERATION AFTER LUBRICATION

- Spray a lock lubricant such as Motorcraft XL-1 into the lock cylinder opening for a couple seconds.
- Operate the door lock cylinder with the key.
- Does the door lock and unlock using the door lock cylinder?

Yes
The concern was caused by an insufficiently lubricated lock cylinder. Spray a multi-purpose grease such as Motorcraft XL-5 into the lock cylinder for a couple seconds to provide long term lubrication.

No
GO to Y2.

-------------------------------------------------
Y2 CHECK THE DOOR LOCK CYLINDER

- Remove the door lock cylinder. Refer to Door Lock Cylinder Service and Repair.
- Operate the door lock cylinder with the key.
- Does the door lock cylinder rotate freely to both lock and unlock positions?

Yes
GO to Y3.

No
INSTALL a new door lock cylinder. REFER to Door Lock Cylinder Service and Repair. TEST the system for normal operation.

-------------------------------------------------
Y3 CHECK THE DOOR LOCK CYLINDER LINKAGE

- Operate the door lock cylinder while observing the rod and lever.
- Is the door lock cylinder rod and lever bent or binding?

Yes
REPAIR as necessary. TEST the system for normal operation.

No
INSTALL a new door latch. REFER to Front Door Latch Front Door Latch. TEST the system for normal operation.

-------------------------------------------------