Procedures

Removal of Instruments

Center Display
Removal of Center Display (whether Standard Speedometer or Navigation Display) is as follows:

- Remove trim from switches (1)
- Remove screw on the lower right side of the instrument cluster trim (2)
- Remove screws on the upper side of the instrument cluster (3)
- Remove lower edge of trim in an outward direction
- After cover is off, remove four screws from Display unit
- Disconnect connectors and remove unit



Remote Instrument Cluster



The following procedure is applicable for all remote cluster configurations
- Remove two screws at rear of instrument cluster
- Disconnect Plug
- Remove Remote Instrument Cluster