Adjusting Rear Axle (With KDS)

Adjusting Rear Axle (With KDS)
Special Tools Required:
^ 32 4 200

If camber is not within specification.

Refer to Troubleshooting on the rear axle (alignment check).

Caution: If unable to bring toe-in within specified values.

Refer to Troubleshooting on the rear axle (alignment check).





Adjusting toe in:
Release screws (1) and (2) approximately 1 1/2 turns at bearing pedestal.
Attach special tool 32 4 200 to screw (2).

Turn special tool and adjust toe-in to specified value.
Compliance housing to body
M12 1.5 66 bolt 100 Nm