67 62 ... Notes on Initializing Power Window

67 62 Notes On Initializing Power Window

WARNING: Risk of injury.

There is no anti-trapping protection during initialization.

An initialization must be performed:
- In the event of malfunctions, e.g. no one-touch control function, no opening or if available no comfort function is possible
- After replacing drive for power window
- After work is carried out on the power window mechanism
- If necessary, after an open circuit, e.g. disconnection of the battery or disconnection of the power supply to the door
- After the door window glass has been removed and installed or replaced
- After adjustment work on the door window glass
- After adjustment work on the convertible top
- After replacement of seals

Initialization is performed on the power window switch of the relevant door.

Requirements for correct initialization:
- Terminal "R" activated
- Doors and windows closed
- Sufficient battery voltage; connect charger if necessary

Erasure of initialization:
- Erasure of initialization
- Reinitialization

Erasure of initialization:
- Move door window glass into middle position
- Disconnect plug connection for power window flat motor or remove plug-in fuse for power window flat motor
- Actuate power window switch several times

This clears initialization of the power window. Anti-trapping protection and one-touch control (toll) function are inactive. Check whether one-touch control (toll) function is inactive, otherwise repeat procedure.

Reinitialization:
- Open door window glass fully
- After reaching lower end position, move without interruption to upper limit and hold switch for at least 2 seconds in "Close" position (second switch position)

This completes initialization.

NOTE:
Carry out function check (one-touch control function, antitrapping protection and, if necessary, comfort function).
The power window can also be initialized in the BMW diagnosis system by means of a diagnosis job.