51 16 060 Removing and Installing or Replacing Inside Mirror

51 16 060 Removing and installing or replacing inside mirror







Version with remote key for central locking system:
If necessary, disconnect negative lead from battery.

Version with compass:
Check compass function if replacing or after disconnecting inside mirror plug connection or battery.
If necessary, calibrate compass in interior rearview mirror.







IMPORTANT:
To avoid windscreen breakage:
Snap out (press) inside mirror only in direction of travel towards windscreen.
Do not under any circumstances twist the mirror base when removing.
Twisting the inside mirror off the mirror base will damage the rear catch.
If the rear catch is damaged, the inside mirror will be loose when installed and must be replaced.







Separate end caps (1) in direction of arrow from each other.
Turn inside mirror (2) and remove end caps (1).







Installation note:
Latch mechanisms (1 and 2) of end caps (3) must not be damaged, replace if necessary.







IMPORTANT:
Risk of damage.
Do not snap inside mirror (1) out of mirror base by turning.

Snap out inside mirror (1) from mirror base towards front with increasing pressure (not abruptly) and remove.







Version with cable (X):
Disconnect plug connection (1) and remove inside mirror (2).







Installation note:
1. Twist mirror foot by approx. 45° and fit to mirror base .
2. Turn mirror foot until it engages on mirror base.







Only replace with version with remote key for central locking system:
Initialize all transmitters (ignition keys), refer to Owner's Handbook.