33 32 076 Removing and Installing/Replacing Top Left Wishbone

33 32 076 Removing and installing/replacing top left wishbone





Note:
If the wishbone is detached from the rear axle support, it is necessary after reinstallation to carry out a chassis / wheel alignment check.





Necessary preliminary work:
^ Remove vehicle underbody cover on left (or right).





Only on right with ride height sensor: Unscrew nut (3).

Installation note:
Tightening torque 37 14 4AZ.

Release nut and remove screw (1).

Tightening torque 33 32 3AZ.

Installation note:
Replace self-locking nut.

Tighten down screw connection in normal position.

Release nut and remove screw (2).

Tightening torque 33 32 1AZ.

Take off wishbone.

Installation note:
Replace self-locking nut.

Tighten down screw connection in normal position.





Replacement:
^ Modify stop pad (1).





After Installation note:
^ Perform wheel alignment check