Programming and Relearning
67 62 ... Notes On Initializing Power Windows
WARNING:
Danger of injury.
There is no anti-trap mechanism during initialization.
An initialization must be performed:
- In the event of malfunctions, e.g. no toll function, no opening or if available no convenience function is possible
- Following replacement of drive for power window regulators
- After work is carried out on the power window mechanism
- If necessary, after an open circuit, e.g. disconnection of the battery or disconnection of the power supply to the door
- After the door window glass has been removed and installed or replaced
- After adjusting procedure on the door window glass
- After adjusting procedure on the convertible top
- After replacement of seals
Initialization is performed on the power window switch of the relevant door.
Requirements for correct initialization:
- Terminal "R" activated
- Doors and windows closed
- Sufficient battery voltage; connect charger if necessary
Initialization comprises:
- Erasure of initialization
- Reinstallation
Deleting the initialization:
- Move the door window into centre position
- Disconnect the plug connection for flat motor power window regulator or remove the plug connection for flat motor power window regulator.
- Operate the power window switch several times
This clears initialization of the power window. Anti-trapping protection and one-touch control (toll) function are inactive.
Check whether one-touch control (toll) function is inactive, otherwise repeat procedure.
Re-initialization:
- Open door window glass fully
- After the lower end position has been reached without interruption, move to the upper block and hold the switch for at least 2 seconds in the "close" position (second switch position)
This completes initialization.
NOTE: Carry out function check (toll function, anti-trapping protection and, if necessary, convenience function).
NOTE: The power windows can also be initialized in the BMW diagnosis system by means of a diagnosis job.