Interior - Repair Info. For R&R Partition Wall Trim Panel
SI M51 10 12Body Equipment
September 2012
Technical Service
SUBJECT
Repair Instruction for Removal and Refitting Partition Wall Trim Panel
MODEL
R58
R59
Produced from June 30, 2011
INFORMATION
If the partition wall trim panel is not removed and installed in the correct sequence, a rattling/squeaking noise may be heard while driving. Refer to the procedure section of this Service Information until the repair instructions are updated in ISTA. Once the repair instructions are updated, this Service Information will be deleted.
PROCEDURE
1. Refer to ISTA/D Repair Instruction 51 46 073. The illustration shows the location of the partition wall trim panels.
2. Remove the trim panel (1) by removing the retaining screw (2). In addition, when removing the trim panel, follow the sequence shown. Start with position (A) and proceed in a counterclockwise direction to (J) to complete the trim panel removal. Use the same procedure to reinstall the trim; again start with position (A) and proceed in a counterclockwise direction to (J).
WARRANTY INFORMATION
Not applicable.