Visual Headlight Horizontal Adjustment

1. Insert a screwdriver in the horizontal adjusting hole and turn it until the "0" mark and the center line of stopper are in alignment.
2. Make sure that the beam pattern which appears on the screen matches the specified beam pattern. If it does not match, adjust as the following procedure:
1. Insert a screwdriver in the horizontal adjusting hole and adjust the horizontal angle to match the specified beam pattern.
2. After pulling out the stopper, push gear B in the direction shown to disengage it from gear A.
3. Align the "0" mark of gear B with the center line of the stopper.
4. Push in the stopper and align the gear A with the gear B.