Round Waterproof Connector

Foreword
Connector which gives loose engagement shall be rectified by removing female terminal from connector housing and raising its lance to establish securer engagement. Removal of connector housing and raising its lance to establish securer engagement. Removal of connector terminal used for ECI and ELC 4 A/T control circuit shall be done.

Round Waterproof Connector:

1. Remove waterproof cap by using a screwdriver.

Round Waterproof Connector:

2. Insert tip of screwdriver [1.4 mm (0.06 in) or 2.0 mm (0.08 in) width] into connector in a manner as shown in the figure. Raise housing lance slightly with it and pull out harness.
3. Insert screwdriver through a hole provided on terminal and raise contact point of male terminal