Alternator and Drive Pulley

1. Refer to the illustration for the service procedure.





2. To install the spacer, align mating marks on camshaft sprocket and camshaft sprocket spacer as shown.
3. Lightly strike the oil seal into the camshaft sprocket spacer until it seats securely into position.





4. Turn the crankshaft clockwise and set the number 1 cylinder position at the top dead center of the compression stroke.
5. Align mating marks on the distributor housing and the coupling.





6. Apply multipurpose grease SAE J310, NLGI number 3 sparingly to the distributor coupling and the entire surface of the oil seal lip and install the distributor.
7. Tighten the crankshaft pulley bolt to 25 Nm (18 ft. lbs.).