Oil Pan, Engine

TIGHTENING SPECIFICATIONS
1. Clean both mating surfaces of oil pan and cylinder block and apply a 4 mm (0.2 inch) wide bead of sealant (Mitsubishi Genuine Part number MD990389 or equivalent) to the entire circumference of the oil pan.
2. Note the difference in bolt lengths at the locations shown.
3. Be sure to install the oil pan quickly while the sealant is wet (within 15 minutes). Torque the mounting bolts to 6.9 Nm (61 inch lbs.).
4. After installation, keep the sealed area away from the oil and coolant for approximately one hour.





5. Install the drain plug gasket in the direction shown.