Overhaul

DISASSEMBLY
Follow disassembly steps outlined in illustration.

NOTE: Disassembly service points are as follows:





a. Steering lock bracket/steering lock cylinder removal (2 & 3).
If it is necessary to remove the steering lock cylinder, use a hacksaw to cut the special bolts at the steering lock bracket side.

ASSEMBLY
Assembly in reverse order as Disassembly.

NOTE: Assembly service points are as follows:





a. Upper boot/lower boot installation (4 & 6).

NOTE: Align the arrows on the upper and lower boots to the slit on the yokes in order to assemble.

Assemble the upper and lower boots and the dust cover.





b. Steering lock cylinder/steering lock bracket/special bolt installation (1, 2 & 3).

CAUTION: The steering lock bracket and bolts must be replaced with new ones when the steering lock is installed.

1. When installing the steering lock and steering lock bracket to the column tube, temporarily install the steering lock so that it is aligned with the column boss.
2. After checking that the lock works properly, tighten the special bolts until the heads twist off.