Center Support

DISASSEMBLY AND REASSEMBLY

DISASSEMBLY SERVICE POINT
SNAP RING REMOVAL

1. Set special tools MD998924 and MB991630 as shown in the illustration so that they are pressed against the inner race of the one-way clutch.
2. Screw in the special tool nut, and lightly press against the inner race of the one-way clutch.
3. Remove the snap ring.

ASSEMBLY SERVICE POINTS
>A< D-RING INSTALLATION
1. Apply ATF to the D-ring.
2. Install the D-ring in the grooves on the outer and inner periphery of the piston. Make sure that the D-ring is not twisted or damaged when installing.

>B< O-ring INSTALLATION

Install the O-ring onto the center support at the position shown in the illustration.

>C< SNAP RING INSTALLATION





1. Set special tools MD998924 and MB991630 as shown in the illustration.
2. Screw in the special tool nut, and lightly press against the inner race of the one-way clutch.
3. Install the snap ring.