Maintenance: Service and Repair

INSPECTION AND SERVICE BEFORE FORDING A STREAM
Vehicles which are driven through water, or which may possibly be driven through water, should be subjected to the following inspections and maintenance procedures in advance.
- Seal the speedometer cable with a water-resistant grease or tape.
- Inspect the dust boot and breather hose for cracks or damage, and replace them if cracks or damage are found.
- Apply grease to the lubricating points of the front suspension, steering linkage and propeller shaft.





INSPECTION AND SERVICE AFTER FORDING A STREAM
After fording a stream, check the following points. If abnormal condition is evident, clean, replace or lubricate.
- Check for water, mud, sand, etc. in the rear brake drum, clutch housing, starter motor, brake pipe and fuel pipe.
- Check for water in the fluid or oil inside the front differential, rear differential, transmission and transfer.
- Apply grease to the lubricating points of the front suspension, steering linkage and propeller shaft.
- Check all boots and breather hoses for cracks and damage.