Valve Body
DISASSEMBLY AND REASSEMBLY
DISASSEMBLY SERVICE POINT
SOLENOID VALVE REMOVAL
Before removing the solenoid valves, make marks with white paint, etc., so that the these valves can be reinstalled in the original positions.
ASSEMBLY SERVICE POINTS
>A< SOLENOID VALVE INSTALLATION
1. Apply ATF, petrolatum jelly or Vaseline to O-ring, and install it to solenoid valves.
2. Following the marks made when removing, install each solenoid valve.
>B< DOWEL PIN INSTALLATION
Install the dowel pin at the specified position on the lower valve body.
>C< KNOCK BUSHING INSTALLATION
Install the knock bushing onto the lower valve body position shown in the illustration.
>D< KNOCK BUSHING INSTALLATION
Install the knock bushing onto the lower valve body position shown in the illustration.
>E< SPRING/STEEL BALL (LINE RELIEF) INSTALLATION
Install the spring [7 mm (0.276 inch) diameter, 17.3 mm (0.681 inch) length] and the steel ball [6.4 mm (0.25 inch) diameter] onto the lower valve body position shown in the illustration.
>F< SPRING/STEEL BALL (ORIFICE CHECK BALL)/BALL (ORIFICE CHECK BALL)/DAMPING VALVE SPRING/SEAL RING/DAMPING VALVE INSTALLATION
1. Install the spring [4.5 mm (0.177 inch) diameter, 15.4 mm (0.606 inch) length] and the steel ball [6.4 mm (0.25 inch) diameter] onto the upper valve body position shown in the illustration.
2. Install the ball (rubber) [6.4 mm (0.25 inch) diameter] onto the upper valve body position shown in the illustration.
3. After installing the seal ring onto the damping valve, install together with the damping valve spring [7.7 mm (0.303 inch) diameter, 35.8 mm (1.409 inch) length] onto the upper valve body position shown in the illustration.
>G< MANUAL VALVE INSTALLATION
Fit and install the manual valve pin into the groove of the manual valve.